Spiral cutter Cmt 4-8 x 15-22 x 60-70 mm, RH, tungsten carbide

NEW AND SHARP TECHNOLOGY
Special super-micrograin carbide formula for an extremely smooth cut
The new low-angle spiral is designed specifically for milling wood and for efficient chip ejection, thanks to which the drill part does not overheat excessively and the life of the cutting edges is longer, compared to a typical end mill.

The highest quality tungsten carbide has been used as the material
2 spiral cutting edges
Excellent end result on both the upper and lower parts of the workpiece to be drilled
Right-handed
Chip ejection from below

Used for drilling, copying and any routing applications of wood, wood composites, plastic materials and laminates
Use a high feed rate on properly fixed workpieces.