REMS press ring M 42 (PR-3S)

Size: M 42

For use with adapter Z2.

REMS press ring for large dimensions, Ø42mm. Put on. Press. Ready.
REMS press rings (PR 3S) - 3 press segments inclined to one joint are designed for pressing large dimensions, also meeting higher demands.
Optimal results are achieved thanks to the radially guided movement of the press segments.
Press contour for M press fitting system Geberit Mapress and other suitable systems.

Control according to EN 1775:2007 - REMS press jaws/REMS press jaws Mini/press rings (with press contour M, V, SA, B, HR and UP) have a special marking pressed in, which leaves a specific mark on it after pressing the fitting. This also makes it possible to check later whether the correct press jaw/press ring was used to press the fitting.
With this traceability, REMS complies with the recommendations of the European standard EN 1775:2007 for the installation of press fitting systems for gas. Example: REMS press jaws M: the imprint "M" on the pressed pipe fitting to ensure traceability according to EN 1775:2007.