YATO voltage tester 12-250 V

Voltage - non-contact test: 12–250 V alternating current (a.c.)
Voltage: 12–250 V direct current (d.c.)
Voltage - contact test: 12–250 V alternating current (a.c.)
Screen type: LCD
Length: 130 mm
Tip: flat
Ground test: yes
Measured voltage frequency: 50–500 Hz
Area of use: electrical work
Continuity test: yes

YT-2861 voltage monitor with LCD screen allows you to determine the presence of alternating current (AC) voltage and detect it by induction method. The presence of voltage is indicated by an indicator displayed on the LCD screen.

AC voltage detection by contact method: 12–250 V
AC voltage detection by induction method
Backlit LCD screen displays measurement results in ranges up to 12, 36, 55, 110 and 220

CONTACT METHOD
Place the tester tip on the active component. The voltage values are displayed on the screen. The indicator shows the highest voltage range and all lower ranges in the circuit being tested. For example, when measuring a 230 V household outlet, the screen displays [12, 36, 55, 110, 220], which indicates a voltage of over 220 V.

INDUCTION METHOD
The method allows to detect AC voltage in an insulated wire. To do this, place your finger on the "Induction Test" field and bring the tip close to the insulated wire. A flash symbol on the LCD screen indicates the presence of voltage. The method also allows to detect a break in a live wire "without contact" - the tester will no longer show voltage at the point of the break.